Dune Buggy

Both sides are done, bolting down the @MeyersManx #DuneBuggy body is back on the ’64 Chassis, @calimports

Posted by Bri on September 16, 2018
Posted in: Dune Buggy, Meyers Manx. Leave a comment

We secured both sides with the stainless steel plates and epoxied to the Fiberglass edge… bolted the body to the chassis and will let it cure for 24 hours… that should reinforce the body edge from all the years of abuse. Oh yeah, and it looks great too, thanks to #Dieter’sMetalFabricating

Dieter’s Metal Fabricating Ltd.

Will tighten it down a little more in the next few days and I will get some pictures ready.

Cheers,

#BadManxBuggy Bri @ http://www.BadManxBuggy.com

Advertisements

Driver’s side is done, bolting down the @MeyersManx #DuneBuggy body is back on the ’64 Chassis, @calimports

Posted by Bri on September 8, 2018
Posted in: Dune Buggy, Meyers Manx. Leave a comment

Took me a bit of time to fit the mounting panel of Stainless Steel courtesy of #Dieter’s Metal Fabricating, turns out that the pattern I mocked up when the #Dunebuggy body was off the chassis was a bit off.

But, check out the fit now …

And , tomorrow I plan to wire up the ignition and too up some fresh fuel and see if I can get the 1974 1600cc fired up.

Crossing my fingers… update to follow tomorrow… sure hope it’s good news.

Cheers,

#BadManxBuggy Bri @ http://www.BadManxBuggy.com